10
TROUBLESHOOTING
If the clothes dryer does not perform as expected or malfunctions, please
check the following list of possible solutions. If a solution can not be found or
the problem persists, please contact TECO service (refer to Page 11).
Do not, under any circumstance, dismantle the appliance.
FAULT POSSIBLE SOLUTION
No lights are illuminated.
Check the selected program.
Check the power cord is securely connected.
Check the house fuse or circuit breaker.
The dryer will not start. Check the door is closed securely.
Check a program has been selected.
Press the Start/Pause button.
Door opens or will not remain Check the door is securely closed and seals.
closed Do not overload the dryer, remove items.
Excessive humidity Check the room is suffi ciently ventilated.
Check air grills are clean and not obstructed.
Check the lint fi lter is clean.
Items still damp or drying time Clean the lint fi lter.
excessive Check the correct program has been selected.
Safety Cut Off and Reset Button
This dryer is fi tted with a safety cut off system which is activated by
excessive heat.
Wait at least 10 minutes for the dryer to cool before pressing the safety
reset button.
The safety reset button is located on the rear of the dryer.
It will only be necessary to press the safety reset button if the dryer is not
heating or the safety cut off system has been triggered.
Press and hold the white reset button in until the reset click is heard.
The safety cut off may be triggered for the following reasons:
1. Lint fi lter is blocked. The most common reason for the dryer overheating is
a blocked lint fi lter. Clean the lint fi lter after each load to prevent this from
occurring.
2. Exhaust outlets obstructed.
3. Insuffi cient ventilation for the dryer to operate safely.
4. Garment obstructing the fi lter.
To Next Page
Loading...