Safety
Precautions
Page 5
ELECTRICAL WARNINGS
•
All electrical wiring must be installed in compliance with the safety requirements of the
current Australian Standards AS/NZS 3000 S.A.A. Wiring Rules, the electrical wiring
required between the indoor and outdoor units must be installed by a competent person.
•
All equipment must be installed in compliance with your local and national Electricity
Authority Rules and Regulations.
•
Do not disassemble or modify unit. This may cause failure and electric shock.
•
Do not open the unit during operation. This may cause electric shock.
•
Disconnect the power if strange sounds, smell or smoke comes from the unit.
CLEANING AND MAINTENANCE WARNINGS
•
Turn off the device and switch off the main power before cleaning. Failure to do so can cause
electrical shock.
• Do not
clean the air conditioner with excessive amounts of water.
• Do not
clean the air conditioner with combustible cleaning agents. Combustible cleaning agents
can cause fire or deformation.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
WARNING
•
If the air conditioner is used together with burners or other heating devices, thoroughly ventilate
the room to avoid oxygen deficiency.
•
Turn off the air conditioner and unplug the unit if you are not going to use it for a long time.
•
Turn off and unplug the unit during storms.
•
Make sure that water condensation can drain unhindered from the unit.
• Do not
operate the air conditioner with wet hands. This may cause electric shock.
• Do not
use device for any other purpose than its intended use.
• Do not
climb onto or place objects on top of the outdoor unit.
• Do not
allow the air conditioner to operate for long periods of time with doors or windows open,
or if the humidity is very high.
This symbol shows that this appliance uses mildly flammable R32 refrigerant.
If the refrigerant leaks and exposed to an external ignition source, there may
be a risk of fire.
This symbol shows that the operation manual should be read carefully.
This symbol shows that information is available such as the operating
manual or installation manual.
This symbol shows that a service personnel should be handling this
equipment with reference to the installation manual.
Explanation of symbols displayed on the indoor unit or outdoor unit:
R32
To Next Page
Loading...
