Page 9
Setting vertical angle of air flow
While the unit is on, use the Swing Button
to set the direction (vertical angle) of airflow.
1.
Press the Swing Button once to activate
the louvre. Each time you press the button, it
will adjust the louvre by 6°. Press the button
until the direction you prefer is reached.
2.
To make the louvre swing up and down
continuously, press and hold the Swing
Button for 3 seconds. Press it again to stop
the automatic function.
The horizontal angle of the airflow can be set by
remote control. Press the Swing Button
button once to activate the
louvre. The vertical
louvre changes 6 degree in angle for each
press. If pressed for more than 3 seconds, the
louvre will swing left and right automatically.
NOTE ON louvre ANGLES
When using COOL or DRY mode, do not set
louvre at vertical position for long periods of
time. This can cause water to condense on the
louvre blade, which will drop on your floor or
furnishings. (See Fig.A)
When using COOL or HEAT mode, setting the
louvre at vertical position can reduce the
performance of the unit due to restricted air
flow.
Do not move louvre by hand. This will cause the
louvre to become out of sync. If this occurs,
turn off the unit for few seconds, then restart
the unit. This will reset the louvre.
Fig. A
CAUTION
Do not put your fingers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
Fig. B
Setting Angle of Air Flow
Setting horizontal angle of air flow
•
Unit
Specifications
and Features
Range
Caution: Do not keep louvre at vertical
position for long periods of time. This
can cause water condensation to drip on
your furnishings.
Deflector rod
The louvre can be taken
down by releasing the
lock block.
To Next Page
Loading...
