TECO TWW22HFWDG - Unit Components and Controls; Part Identification; Air Direction Adjustment; Main Switch Operation

Part identification
For TWW16CFDG Only
Cabinet
Cabinet
Air inlet louver
Air inlet louver
Front grille
Front grille
Front intake grille
Front intake grille
Remote control panel
Power cord
Air filter
(behind the front intake grille)
Power cord
Air filter
(behind the front intake grille)
Control panel
All images are for Illustration purposes only.
Air direction adjustment
Vertical airflow direction vane
(Airflow direction adjustment up and down).
The vertical airflow direction vane is controlled by positioning the vane
to discharge the air upwards, downwards or straight out.
Main switch operation procedure
For TWW16CFDG Only
1. Main Control Knob
Set to select Low Cool, Med Cool, High Cool or Fan Only as desired.
CAUTION: WAIT at least 3 minutes before resetting to cooling operation, if it has been turned
off or set to Fan.
2. Thermostat Knob
Set thermostat knob to select your desired room temperature (usually 6~7 is recommended).
Adjust setting after a short if your desired temperature be obtained. The
evaporator fins may be fr up, if you set knob to 10. Turn it back counter-clockwise to
resume normal operation.
3. Air Swing Switch
(Airflow direction adjustment Side-to-Side)
To the air swing switch to “ON” for the
vanes to swing side to side until the desired flow direction is
switch it to “OFF”. For continuous side-to-side air circulation, set the air
swing switch to “ON”.
AIR SWING
OFF
ON
11
period
ozen
cannot
obtain a fix airflow direction, set
from
then
reached,