Name & Func on of Wireless Remote Control
(Not applicable to TWW16CF
DG)
Ensure there are no obstruc ons between receiver (air condi oner front panel) and remote controller.
Do not drop or throw the remote control.
Do not let any liquid in the remote control.
Do not place the remote control in direct sunlight or any loca n with excessive heat.
13
Remote Control
1
On/Off button
2
Mode button
3
4
Swing button
5
Fan button
6
Sleep button
7
Timer button
8
WiFi button
+ / - button
2
4
7
8
6
5
3
1
5
1
On/Off button
Press this button to turn on the unit. Press this button again to turn off the unit.
2
Mode button
Press this button can your required operation mode in turn. Corresponding indicator will be on.
Cool:
can adjust the fan speed.
Under this mode, air conditioner operates under cooling mode. Cooling indicator will be on. Press “Fan Speed” button
Auto: Under this mode, the
unit will operate automatically
according to ex-factory setting.
In this case, set temperature
cannot be adjusted.
Dry HeatCoolAuto
Fan
Only
3
+ / - button
Under timer setting status, after each pressing of “+” or “-” button, time will
Pressing “+” or “-” button once will increase or decrease set temperature by 1°C (°F).
Hold “+” or “-” button for 2s, set temperature on remote controller will change.
Release the button after your required set temperature is reached.
increase or decrease 0.5h . Hold “+ ” or “-” button, 2s later, time displayed
on dual-8 nixie tube will change quickly. Loosen the button until the time is
reached to your set time.
4
Swing button
Press this button to turn “ON” & “OFF” swing.
Heat:
NOTE: When in HEAT mode, the operation may stop from time to time to perform defrost function. During defrost H1 will
be displayed. See page 16.
(Cooling only unit won’t receive heating mode signal. If set to heating mode with remote controller and ON/OFF button
Under this mode, air conditioner operates under heating mode. Press “Fan Speed” button can adjust the fan speed
Fan Only:
button can adjust the fan speed.
Under this mode, air conditioner will not cool or heat, only blow wind. Fan indicator will be on. Press “Fan Speed”
Dry:
mode, the fan speed cannot be adjusted.
Under this mode, the unit runs in low fan speed for dehumidification and the corresponding indicator is on; under dry
time to time to perform defrost
To Next Page
Loading...
