Name & Func on of Wireless Remote Control
(Not applicable to TWW16CFDG)
14
5
Fan button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
NOTE: There are 3 speeds for the Fan Speed of this model.
, , to then back to Auto.
Auto
Speed 1 Speed 2
Speed 3
Function introduction for combination buttons
Under OFF status, press "-" and "Mode" buttons simultaneously to switch temp-
erature display between °C and °F
Under switch-on or switch-off state, you may hold "+"and "FAN" buttons
simultaneously to set the lamp on or off and send the code. After being energized
the lamp is defaulted on.
Temperature display switchover function
Light function
● This function is not available for TWW16CFDG.
● Smart phone requirement.
● Ewpe Smart App is required and installed on the smart phone.
Search "Ewpe Smart" in the application market to download and install it.
For more information please check Ewpe Smart App Operation Manual.
6 Sleep button
Press this button to go into the Sleep operation mode. Press it again to cancel this function. This function is
available in COOL, HEAT (Only for models with heating function) mode to maintain the most comfortable
temperature for you.
7 Timer button
Under ON status, press this button to set timer OFF; Under OFF status, press this button to set timer ON.
Press this button once and the characters of HOUR ON (OFF) will flash to be displayed. Meanwhile,
press “+”
button or “-” button to adjust timer setting (time will change quickly if holding “+” or “-” button).
Time setting range is 0.5~24 hours. Press this button again to confirm timer setting and the characters of
HOUR ON (OFF) will start flashing.
If the characters are flashing but you haven’t pressed the timer button, timer setting status will quit after 5s.
If the timer is confirmed, press this button again to cancel the timer.
9 WiFi button
When WiFi function is turned on, " WiFi " icon will be displayed on the remote controller; when WiFi function is turned
off by pressing the WiFi button, the icon will no longer be displayed.
How to turn on WiFi：Press " WiFi " button to turn on WiFi function.
How to turn off WiFi：Hold " WiFi " button for 5s to turn off WiFi function.
Under off status, press "MODE" and " WiFi " buttons simultaneously for 1s, WiFi module will restore factory settings.
To Next Page
Loading...
