DURESS OPTION
The duress facility is activated by using a duress digit in conjunction with your PIN. The
duress digit is the last digit of your PIN, plus one (1).
Eg.
PIN=1234 – duress digit = 5. If the last digit is 9, the duress digit is 0.
To Activate Duress: (The bottom line of the display must show “Code:”)
1 2 3 5 (Normal PIN = 1234) <OFF> or <ON> or <ENTER>
Use of your duress PIN code will still activate the functions associated with the PIN.
When duress is activated, the display will show three full stops before the display text.
Reset Duress:
To reset the duress facility (ie. Turn off the signal), enter a valid PIN code. The display
will return to
There Are No Alarms In This Area
etc. The …, will be removed.
Note:
If Duress was a false alarm it is important that you contact your monitoring
company to ensure that no further action is taken by them.
DOOR OPENING OPTION
A
Challenger
console may be used to open a door, by entering a door code. Your door
code is related to your PIN. It varies, depending on whether your PIN has been
programmed to allow you to arm/disarm your system, as well as open doors.
To open a door: (The bottom line of the display must show “Code:”)
3 4 5 6 (Your Door code) <ENTER>
Notes:
1. If the console sounds 7 quick beeps when you enter your door code, an
Invalid code has been entered, or the code is not valid at this arming
station.
2. A door code will only open doors programmed to be opened by that
code.
To Next Page
Loading...
