Need help?Do you have a question about the TECOM CHALLENGER and is the answer not in the manual?
General| Category | Control Panel |
|---|---|
| Frequency | 50/60 Hz |
| Weight | 1.5 kg |
| Enclosure Protection | IP30 |
| Operating Temperature | 50°C |
| Humidity | non-condensing |
| Material | Plastic |
Explains how system functions depend on programming and organizational requirements.
Process of entering a PIN on the keypad, indicated by '*' on display.
Procedure to activate a silent signal to security by entering PIN with a duress digit.
Procedure to open a door using a door code on the Challenger console.
Step-by-step guide for arming the system, including PIN entry and area selection.
How to arm specific areas by selecting them.
Procedure to disarm the system by using the OFF key.
Step-by-step guide for disarming the system, including PIN entry and area selection.
Alarm transmitted within the building for occupied areas, rectifiable on-site.
System state when an armed input device is activated, requiring PIN to reset.
Alarm due to device tampering, communication loss, or system faults.
Rectifies the cause of a local alarm to prevent recurrence.
Procedure to reset an alarm after its cause has been cleared.
Steps to access the system menu after entering the PIN.
How to choose a specific function from the menu by entering its number.
Displays results of tests on inputs operating when building is unoccupied.
Displays results of tests on inputs and cameras operating when building is occupied.
Initiates a request for a service technician.
Status indicating a sealed input is functioning correctly.
Status indicating an unsealed input may need attention.
Indicates an OPEN circuit fault from cable tampering.
Procedure to remove a user from the system.
Add or modify user details, flags, and assignments.
Steps for programming non-Tecom magnetic cards as system users.
To Next Page
