51
The Challenger Version 8.0 User Guide : Issue I , Revision I : October 1997
PROGRAM USERS - Menu Option 14
Special Procedure for programming non-Tecom magnetic card formats.
The following procedure must be used to allow non-Tecom format magnetic cards such as credit cards, financial
institution cards, etc. to be programmed in the Version 8 Challenger System as Users.
Your system must be equipped with the appropriate card reader in order to perform this function.
1) Swipe the card in the reader.
2) If the card is not recognised by the system, an event will be logged in history and on the printer (if fitted);
"Card/Pin" followed by an enrolment number of up to 10 digits. e.g. Card/Pin ??????????
Make a note of the enrolment number. This number will be recorded as the PIN code when
programming the user.
3) Follow the procedure for "CREATE (and CHANGE) A USER" but note the following points:
STEP 1Select a user. The user number MUST be below 1000 but does NOT have to be the card number
for these types of card.
STEP 6User Flags. If you do not wish the enrolment number to be used as the User's PIN code, the
User Flag "Card Only" must be set to YES.
(If the user flags are not displayed when programming user's, ask the installer to
enable "Display User Flags" in the System Options)
STEP 9PIN Code. The enrolment number is entered here.
See Also: User Identification.
Important Note! Always remember to update your "User" List when any changes are made.
Figure 2 :
Keypad Layout for entering text
Key 1st2nd3rd4th5th6th7th
1......... A....B....C....1.....a.....b....c
2......... D....E....F.....2.....d.....e.....f
3......... G....H...I......3.....g.....h....i
4......... J.....K...L.....4.....j.....k....l
5......... M...N...O....5.....m....n....o
6......... P....Q...R....6.....p.....q....r
7......... S....T....U....7.....s.....t.....u
8......... V....W..X....8.....v.....w....x
9......... Y....Z....sp....9.....y.....z.....sp
0......... ......-.....&....0............-.....&
(sp=space)
www.msealarms.com.au