TECOM CHALLENGER - Time and Date - Menu Option 15; Option 1: Display and 2: Set

52 V8-U-TXT.PM6 : Issue I , Revision I : October 1997
TIME AND DATE - Menu Option 15
This function is used to program a new time and date.
The time and date are not visible during normal use of The Challenger however all internal functions are reliant on them.
A new date or time would only need to be programmed when The Challenger is first installed or if the time needs to be
adjusted for daylight saving.
Time options : 1. Display 2. Set 3. DST (Daylight Saving Time) 4. Correct
The time is programmed for a 24 hour clock.
Option 1. Display and 2. Set
1. The display will show:
Time & Date hh:mm dd/mm/yy Xxxxday
Hours:
(Where hh:mm dd/mm/yy Xxxxday = the current time and date held by the system as hour, minute, day,
month, year and day of the week.)
? ? ~ Select the correct hour.
ENTER ~ Update the hour and go the next display.
2. The display will show:
Time & Date hh:mm dd/mm/yy Xxxxday
Minutes:
? ? ~ Select the correct minutes.
ENTER ~ Update the minutes and go to the next display.
3. The display will show:
Time & Date hh:mm dd/mm/yy Xxxxday
Day:
? ? ~ Select the correct day.
ENTER ~ Update the day and go to the next display.
4. The display will show:
Time & Date hh:mm dd/mm/yy Xxxxday
Month:
? ? ~ Select the correct month.
ENTER ~ Update the month and go to the next display.
www.msealarms.com.au