23
The Challenger Version 8.0 User Guide : Issue I , Revision I : October 1997
LOCAL ALARM
Acknowledge the local alarm:
You must acknowledge the local alarm to stop the console tone.
ENTER ENTER ~ Press (twice) The input/s causing the alarm are listed.
0 ~ Enter
ENTER ~ Press
This will acknowledge all local alarms, stop the tone and return the display to There Are No Alarms In This Area.
Reset the local alarm:
To ensure the local alarm does not recur, you must rectify whatever was causing it. ( eg. close door)
The A preceding the input number on the display will be shown only on inputs where the local alarm has not been
acknowledged.
Re-alarm:
If your system has been programmed with a reminder on local alarms, it will re-alarm after a pre-set time unless the cause
has been fixed. It will continue to re-alarm, regardless of acknowledgment each time, unless the alarm cause is fixed.
When a re-alarm does occur, the letter preceding the input number will not be shown.
See Also: Alarm
Panel Status - Menu Option 1
Inputs in Alarm - Menu Option 3
www.msealarms.com.au
To Next Page
Loading...
