13
The Challenger Version 8.0 User Guide : Issue I , Revision I : October 1997
The arming procedure is used (when leaving the premises) to set devices in your system to cause an alarm should there
be a change in their condition. You are turning on the security for an area or building which is unoccupied.
- The arming procedure will vary depending on how your system is programmed.
The recommended OFF/ON procedure is described in this User Guide.
- Each arming station controls specific area/s.
Only the area/s controlled by an arming station can be armed at that arming station.
- Each PIN will only be authorized to arm specific area/s.
When an arming procedure is used, only the area/s assigned to the PIN will be armed.
- It is not possible to arm an area with an unsealed input.
If at any time during the arming process the console sounds 7 quick beeps and displays the word unsealed,
refer to the section on Unsealed Inputs.
- After an area is armed you will have a pre-set time to exit the area before an alarm occurs.
ARMING YOUR SYSTEM
www.msealarms.com.au
To Next Page
Loading...
