42 V8-U-TXT.PM6 : Issue I , Revision I : October 1997
TEST INPUT - Menu Option 12
This function is used to test an individual input device to determine if it is operating correctly.
The display will show:
Test Individual Input:
Input No:
ENTER ~ Return to the menu.
or ? ENTER ~ Test the selected input.
If you selected an input, one of four responses may be given:
a/The input is sealed eg. SEALED On 12, Roller Door
Press ENTER
b/The input is unsealed eg. UNSEALED On 12, Roller Door
Press ENTER
c/There is a faulty condition due to cable tamper. The cabling to the input shows an OPEN circuit.
eg. OPEN On 12, Roller Door
Press ENTER
d/There is a faulty condition due to cable tamper. The cabling to the input shows a SHORT circuit.
eg. SHORT On 12, Roller Door
Press ENTER
From each of these displays:
ENTER ~ Return to the original menu option display.
Notes: 1. If an input is unsealed, open or short, the console will emit a continuous tone. When the status of the input
is changed to sealed, the display will be updated and the tone will stop.
2. If the input is isolated when a test is requested on it, the system will de-isolate the input, conduct the test
then return the input back to isolated.
3. There is a pre-determined time in which to complete the test. If the test is not completed within this time,
the option is exited.
See Also: Secure Test
Access Test
www.msealarms.com.au
To Next Page
Loading...
