44 V8-U-TXT.PM6 : Issue I , Revision I : October 1997
PROGRAM USERS - Menu Option 14
This function allows you to add, delete or create a user.
Your system may have been set up to require two authorised users to enter this menu.
The user programming includes a record of:
- The Challenger user (or card) number. This is a number between 1 and 11,466* which is used by the system to
link a PIN or card to the functions it will perform and the doors it can enter.
Note:When programming cards, the ID number programmed in the card is the user number
(Unless your system uses a card offset).
- The user’s alarm group which determines the user's area/s, & alarm control functions. eg. Manager, Staff etc.
(Note:Your own alarm group may or may not allow you to program PIN codes. If it does allow use of the function,
there may still be restrictions on which alarm groups you are allowed to update)
- The users door group which determines which doors the user has access to.
- The users floor group which determines which floors the user has access to.
- The user’s name (some users only).
- The users PIN code (some users only). Note: Card ID numbers are NOT programmed as the PIN code.
If your system requires two users to access (dual custody) this option, the display will show:
Enter Second Code
Code:
? ? ? ? ~ Enter second users PIN
ENTER ~ Press
The display will show:
1-Delete 2-Display 3-Create
Option:
? ENTER ~ Select the function you wish to perform. See Note 1.
or ENTER ~ Return to the menu.
*Note: Only 50 users with name, PIN and/or card can be programmed in a system with standard memory.
In a system with expanded memory:
- Only the 1st 200 users can have their name programmed to their user number.
- Only the 1st 1000 users can have a PIN assigned to them.
- Users 1 to 1000 can have a PIN and/or card.
- Users 1001 to 11,466 can only have a card.
www.msealarms.com.au
To Next Page
Loading...
