32 V8-U-TXT.PM6 : Issue I , Revision I : October 1997
INPUTS ISOLATED - Menu Option 4
This function is used to display details of all isolated inputs. An isolated input is one which is excluded from functioning
as part of the security system. It would be isolated because it is faulty or broken and by isolating it you would stop it causing
an alarm. This function would therefore be used to determine which inputs are not operational and need attention.
No isolated inputs:
The display will show:
No Isolated Inputs
Press ENTER
ENTER ~ Return to the menu.
or NEXT ~ Update the status.
Isolate inputs are listed either:
One at a time eg. Isolated On 4. Beam Across Loading Bay
NEXT or ENTER
or
As a list of numbers eg. Isolated On 1, 2, 6.
Input No:
From either display:
NEXT ~ Update the list of inputs and display the next inputs in the list (if any).
or ENTER ~ Return to the menu.
or ? ENTER ~ Display the input name in full.
Note: Using Panel Link changes the standard numbering system seen here, to reflect that of Panel Link's system.
See Also: Panel Status - Menu Option 1
www.msealarms.com.au
To Next Page
Loading...
