15
The Challenger Version 8.0 User Guide : Issue I , Revision I : October 1997
ARMING YOUR SYSTEM
b/Arm individual areas
? ~ Enter the area number
ENTER ~ Press
This will arm the selected area immediately and remove it from the display.
If there are more areas than can be shown on the display the list will now show the next area.
You may arm any of the areas listed by selecting them in this way.
When arming is complete, press ENTER to return to the display shown in step 1.
c/Cancel the function
ENTER ~ Press
This will cancel the function and return you to the display shown in step 1. If you have already armed areas
prior to using this function, the areas will remain armed.
d/Display more areas
NEXT ~ Press
This will display the next disarmed areas in the list and update the information. Select from these areas to arm
the individual area (as shown in b/ above) or continue to press NEXT to view all the areas and return to the
first display.
4. The area light(s) will illuminate when the arming procedure has been successful.
www.msealarms.com.au
To Next Page
Loading...
