The power cable must be connected directly to the battery or to a regulated
power supply.
The power supply must be protected with a 10A fuse.
If it is not the case, TECOMEC S.r.l. will not be responsible for any damage to
the microcomputer.
Disconnect the power cable from the microcomputer when charging the vehicle
battery.
If it is not the case, TECOMEC S.r.l. will not be responsible for any damage to
the microcomputer.
Disconnect all cables from the Monitor before undertaking welding on the
vehicle.
If it is not the case, TECOMEC S.r.l. will not be responsible for any damage to
the microcomputer.
To ensure the correct operation, make sure that the battery always has a
voltage higher than 10.5 Volt.
This symbol on the product or on its packaging illustrates that
this product must not be disposed of with normal household
waste.
It is the responsibility of the user to dispose of this equipment
through a designated waste electrical and electronic
equipment collection site. To find the locations to dispose of
such electrical and electronic waste, contact your local waste
disposal service or the company you purchased the product from.
Before cleaning the agricultural vehicle with high pressure water jets, protect the
equipment from any possible ingress of water. In addition, take care not to
subject the devices, cables or connectors to direct jets of water.
If the equipment needs to be cleaned, use a soft, damp, lint-free cloth. Do not
use sprays, solvents, abrasives, or sharp or pointed objects that could damage
the housing.
6 PACKAGE CONTENTS
To Next Page
Loading...
Need help?
General