p. 3
Safety instructions
WARNING!
• Please keep this User Guide for future consultation. If
you sell the unit to another user, be sure that they also
receive this instruction booklet.
• All xtures are intact from the manufacturer, please op-
erate follow up the user manual, articial fault are not
under guarantee repair.
• Unpack and check carefully that there is no transporta-
tion damage before using the unit.
• The unit is for indoor use only. Use only in a dry location.
• Do install and operate by operator.
• Use safety chain when xes the unit. Don’t handle the unit
by taking its head only, but always by taking its base.
• The unit must be installed in a location with adequate
ventilation, at least 50cm from adjacent surfaces.
• Be sure that no ventilation slots are blocked, otherwise
the unit will be overheated.
• Before operating, ensure that the voltage and frequency of
power supply match the power requirements of the unit.
• It’s important to ground the yellow/green conductor to
earth in order to avoid electric shock.
• Maximum ambient temperature TA : 40°C. Don’t operate
it where the temperature is higher than this.
• Don’t connect the device to any dimmer pack.
• First run, there will be smoke or smells, and all disap-
pearing a few minutes later.
• Make sure there are no ammable materials close to the
unit while operating, as it is re hazard.
• Look over power wires carefully, replace immediately if
there is any damage.
• Never run on for a long time lest shortening lifespan.
• Avoid any inammable liquids, water or metal objects
entering the unit.
• Once it happen, cut o the mains power immediately.
• Do not operate in dirty and dusty environment, also
cleaning xtures regularly.
• Do not allow children to operate the xture.
• Do not touch any wire during operation as there might
be a hazard of electric shock.
• Avoid power wires together around other cables.
• Disconnect mains power before fuse/lamp replacement
or servicing.
• Replace fuse only with the same type.
• In the event of serious operating problem, stop using the
unit immediately.
• Never turn on and o the unit time aer time.
• The housing, the lenses, or the ultraviolet lter must be
replaced if they are visibly damaged.
• Do not open the unit as there are no user serviceable
parts inside.
• Never try to repair the unit by yourself. Repairs carried
out by unskilled people can lead to damage or malfunc-
tion. Please contact the nearest authorized technical as-
sistance center.
• Disconnect the mains power if the xture is not used for
a long time.
• Do use original packing materials once transport it again.
• Do not look directly at the LED light beam while the x-
ture is on.
For power supply, do not connect in series much more
than 7 units, use another mains supply for next 7 units.
Please read the instructions carefully which includes important information about the installation, operation and maintenance.
NEBULA 6 - 12W * 6PCS LED PAR LIGHT
English Version
To Next Page
Loading...