To Next PageTo Next PageWhy does my Tecsun Receiver keep turning off?
If your Tecsun Receiver turns off while you are listening, the battery may be out of power; replace or charge it. Also, the sleep timer might be activated; turn the radio on again.
Why is AM reception so poor on my Tecsun Receiver in the USA?
If you are experiencing poor AM reception in the USA on your Tecsun Receiver, it may be because the device is set to 9kHz tuning steps while the USA uses 10kHz. To resolve this, turn off the radio and press the [9/10kHz] button to select the accurate tuning step.
What to do if my Tecsun Receiver is malfunctioning?
If your Tecsun Receiver is malfunctioning, it may be due to interference causing the microchip to not function properly. Remove the battery and reinstall it once the device's display has turned off completely. If it still does not work, press the reset button with a pointed object.
Why is the charging time on my Tecsun Receiver getting shorter?
If the charging time for your Tecsun Receiver is becoming shorter, it is likely that the rechargeable battery is getting old. Replace the old rechargeable battery with a new one.
What to do if some stations aren't stored during ATS on my Tecsun Receiver?
If, during ATS on your Tecsun Receiver, some stations cannot be stored or some stored stations have noise, it could be due to a weak signal. Try to search for the station manually. Alternatively, there may be interference in your area. Contract the antenna or move to another location and try again.
How to fix Tecsun Receiver when only few FM stations can be received?
If you can only receive a few FM stations on your Tecsun Receiver, the FM frequency may have been accidentally set to 76 - 90MHz. Turn off the radio, then press and hold the [FM SET] button to select the accurate FM frequency range.
How to fix low SW SSB broadcasting sound on Tecsun Receiver?
If the sound of SW SSB broadcasting on your Tecsun Receiver is too low, press the [AM BW] button to select the Wide band.
Why is there only noise when the alarm goes off on my Tecsun Receiver?
If, when the alarm goes off on your Tecsun Receiver, there is only noise, you may not have set the proper radio station for the alarm. Preset your alarm station properly. It is also possible that there is no broadcasting at that frequency; make sure it is possible to receive radio broadcasts at your location.
General| AM Frequency Range | 520 - 1710 kHz |
|---|---|
| LW Frequency Range | 100 - 519 kHz |
| SW Frequency Range | 1711 - 29999 kHz |
| Headphone Jack | 3.5 mm |
| Dimensions | 192 x 113 x 33 mm |
| Modes | AM, FM, LW, SW |
| FM Frequency Range | 64 - 108 MHz |
| Tuning Steps | 1 kHz (AM/SW) |
| Selectivity | FM: >60dB / AM: >40dB |
| Audio Output | 450mW |
| Power Supply | DC 5V |
| Battery Life | Up to 20 hours |
| Additional Features | alarm clock, sleep timer |
