TECTOOL NTS 30 PREMIUM - Operation and Maintenance; Operating Controls and Modes; Vacuuming Procedures

18
Assembling accessories:
1. After connecting the vacuum hose (Fig. 1 /Pos.2), push the handle (Fig.1 /Pos.19) into the telescopic vacuum
pipe (Fig. 1 /Pos.14).
2. Press the unlock button for the telescopic vacuum pipe (Fig. 1 /Pos.17) to extend the telescopic vacuum
pipe (Fig. 1 /Pos. 14).
Installing brushes and nozzles:
1. Select the brush or nozzle suitable for the relevant job.
2. Push the telescopic vacuum pipe (Fig. 1 /Pos. 14) into the required brush or nozzle.
Floor nozzle (Fig. 10) – to vacuum carpets (setting A) and hard surfaces (setting B). Also suitable for wet
vacuuming.
Joint nozzle (Fig. 1 /Pos. 23) – for locations that are difficult to access, e.g. edges, radiators.
Brush nozzle (Fig. 1 /Pos. 24) – to remove dust from highly sensitive pieces of furniture or items susceptible to
scratching.
OPERATION
Switching on:
Tip the on/off switch (Fig. 1 /Pos.15) into the ─ position to switch the device on.
Switching off:
Tip the on/off switch (Fig. 1 /Pos.15) into the 0 position to switch the device off.
Switching on with an electrical device connected:
Tip the on/off switch (Fig. 1 /Pos.15) into the ═ position to switch the device and the connected electrical device
on.
Speed regulation:
The vacuuming force can be adjusted using speed regulation (Fig. 1 /Pos. 5).
- Turn speed regulation clockwise to increase the speed and suction force.
- Turn speed regulation anticlockwise to reduce the speed and suction force
Dry vacuuming (Fig. 1):
Warning! Pull out the mains plug before carrying out any adjustments, maintenance or repair work.
Dry vacuuming
- Ensure that the dust bag (25) is installed.
- Fill the water tank (11) up to the line
- Affix the hose connection cover (13) to the water tank (11).
- Loosen the quick coupling (8) on both sides of the device and remove the machine head.
- Install the HEPA filter (21).
- Re-attach the machine head to the water tank (11).
- Fit the vacuum hose (2) to the machine head.
- Select the required brush or nozzle.
Wet vacuuming (Fig. 1):
- Remove the dust bag (24).
- Fasten the cover (13) for the hose connection on the machine head.
- Install the vacuum hose (2) with the floor nozzle (12) on the water tank (11).
- Loosen the quick coupling (8) on both sides of the device and remove the machine head.
- Install the foam filter (20).
- Re-attach the machine head to the water tank (11).
Automatic mode:
- Plug your electrical tool’s cable into the socket (Fig. 1 /Pos. 7).
- Connect the vacuum hose (Fig. 1 /Pos. 2) to the dust vacuuming connection on your electrical tool. Ensure
that the device connections are air tight.
- Tip the on/off switch (Fig. 1 /Pos.15) into the ═ position.
- The wet and dry vacuum cleaner switches on as soon as the electrical tool is switched on. When you switch
your electrical tool off, the wet and dry vacuum cleaner switches off with the preset delay tapping function.
If the vacuuming power reduces during dry vacuuming, press the tapping function button (Fig. 1 /Pos. 18) a
few times to clean the HEPA filter.