9
Connecting Component Cables
Now that you have the console installed you can begin connecting it to the other
components of the 844 system. The standard kit contains a main cable that
attaches to the boom control valves, the pressure regulating valve, flow meter
and/or pressure sensor, and a magnetic wheel speed sensor, proximity speed
sensor or radar speed sensor.
Lay out each of the valve and sensor leads before installing the sprayer
components to be sure the cables are long enough in length from the sensor
connections to the 844 console connection. If your installation requires longer
cables, several extension cables are available.
If an exit hole had to be cut in the cab, be sure the edges are deburred and
protected to prevent damage to the cables.
4
CONSOLE
STEP
844 SPRAYER CONTROL
TANK
POWER
JET AGITATOR
SPEED SENSOR
SOLENOID VALVES
BOOM SECTIONS
STRAINER
TANK SHUT-OFF
CENTRIFUGAL
PUMP
AGITATOR
VALVE
PRESSURE
TRANSDUCER
(IF USED)
PRESSURE
REGULATING
VALVE
10-12˝
(25-35 CM)
5-7˝
(12-17 CM)
FLOW METER
(IF USED)
COMMUNICATION
CABLE CONNECTION
MAIN CABLE CONNECTION
FIGURE 9
W
IRING DIAGRAM
To Next Page
Loading...
