Teemi TMCT-07 - Automatic scanning Mode

Automatic scanning Mode
Under the Automatic scanning Mode, the users just need to move the barcodes to be
scanned in front of the light band of TMCT-10, no need press the Scan Key, there will
show a red light line. This indicates the scanner could scan; the scanning will not stop until
the scanner under the following situation.
* Read a barcode successfully;
*The pre-set timeout expires (the default time is 2s).
The steps to activate the automatic scanning mode are as follows:
1. Read the "Enter Setup" barcode;
2. Read the "Automatic scanning Mode" barcode;
Automatic scanning Mode
3. Read the "Exit with Save" barcode.
Beeper Volume
Enter Setup
Exit with Save
Mute
Minimum Volume
（*）Medium Volume
Maximum Volume