Incorrect Aiming
1. Restore Factory Defaults
"Restore Factory Defaults" is a special barcode. The TMCT-10 Barcode Scanner will
respond with a short beep (high tone) after reading this barcode. At this time, the scanner
system could restore factory defaults, and no need to read "Exit with Save" barcode again.
The Scanner defaults enable HID, PIN defaults 10010.
Note: Most of setting mode have restore factory defaults selection. The factory default
value for each setting is indicated by an asterisk "*".
You could use this barcode at the following status:
1、The scanner cannot work. For example, it cannot read barcodes.
2、You forget the settings you did to the scanner before, and you don't want to be affected
by the settings when you use the scanner.
3、After using a function which is not be used usually in the scanner.
2. Steps of Programming the scanner:
If you like to configure and modify one or a couple of the TMCT-10 or TMCT-07 scanner’s
properties, you may do so by following the scanning steps shown below:
“Enter setup mode” -> [configuration barcode(s)] -> “Exit with save”.
To Next Page
Loading...
