87
Switch the steam generator on
• Put the steam generator on a flat, stable, horizontal
surface that is heatproof.
• Always ensure that the base unit is positioned close
enough to the ironing surface to avoid straining and
wear of the steam cord.
• Completely unwind the power cord and take the steam
cord out of its storage space.
• Plug your steam generator into an earthed socket.
• Press the «ON-OFF» button.
• The «ON-OFF» button light remains flashing while the
appliance is warming up. When the light stops flashing
(after approximately 2 minutes) the steam generator
is ready.
ON
OK
Operating the control panel
• The blue light of the «ON-OFF» button is flashing : the
boiler is heating up. When the light stops flashing, the
steam generator is ready.
• The red «Water tank empty» button light is flashing :
the water tank is empty. See paragraph «Refilling the
water tank during use»
• The orange «Anti-calc» light is flashing : maintenance
is required, see paragraph «Maintenance and
cleaning».
• Your steam generator comes with an automatic
shut-off system after approximately 8 minutes
without use. The «ON-OFF» button light is flashing: the
steam generator is on standby. Press the «ON-OFF»
button or the steam output button to start ironing
again. See paragraph «AUTO-OFF» System.
The first time the appliance is used, there may be
some fumes and smell but this is not harmful. They
will not affect use and will disappear rapidly.
To Next Page
Loading...
Need help?
General