Need help?Do you have a question about the Tegeler Creme and is the answer not in the manual?
Signal passes directly unprocessed in bypass mode or when switched off.
Determines output level; set to avoid clipping and match loudness.
Power switch starts/stops device; LED indicates operation.
Activates a high-pass filter in the sidechain to avoid low-frequency triggering.
Switch to set the order of EQ and compressor processing for different sound effects.
Sets the signal level at which the compressor becomes active.
General| Frequency Response | 20 Hz - 20 kHz |
|---|---|
| Controls | Threshold, Ratio, Attack, Release |
| Metering | Gain Reduction |
| Inputs | 2 x XLR |
| Outputs | 2 x XLR |
| Channels | Stereo |
To Next Page