Teka CI2 350 NF - Maintenance Tasks; Replacing the Interior Light Bulb

EN

Replacing the interior light
bulb
Should the light fail to work, proceed
as follows.
1- Switch off at the socket outlet and
pull out the mains plug.
You may find it useful to remove
shelves for easy access.
2- Use a flat tipped screwdriver to
remove the light diffuser cover.
3- First check that the bulb hasn’t
worked loose by ensuring it is screwed
TFDVSFMZJOUIFIPMEFS3FQMBDFUIFQMVH
and switch on.
If the bulb works, replace the light
cover by inserting the rear lug and
pushing up to locate the front two lugs.
4- If the light still fails to work, switch
off at the socket outlet and pull out
UIFNBJOTQMVH3FQMBDFUIFCVMCXJUI
a new 15 watt (max) screw cap (SES)
bulb.
5- Carefully dispose of the burnt-out
light bulb immediately.
3FQMBDFNFOUMJHIUCVMCDBOFBTJMZCF
obtained from a good local electrical or
DIY store.