Why isn't the heating pilot light turning on in my Teka Oven?
If the heating pilot light on your Teka Oven does not turn on, make sure that you have selected a temperature and a setting. Remember that the pilot light should only come on while the oven is heating up to the selected temperature.
What to do if the Teka Oven door is locked after the pyrolysis programme ends?
If, after the pyrolysis programme of your Teka Oven has ended, the oven is cold, but the door is locked, set the control dial to the correct position.
What to do if the Teka HS C door is still locked with the control dial in position?
If the control dial of your Teka Oven is in the correct position and the door is still locked, wait until the oven cools down to a safe temperature and the symbol goes off.
How to troubleshoot a Teka Oven that stops working?
If your Teka Oven stops working, start by checking the power connection to ensure it's properly plugged in. Then, inspect the fuses and circuit breaker in your home's electrical panel. Also, verify that the oven timer is set to either the manual or a programmed setting, and confirm that the control and temperature dials are correctly positioned.
Why is my Teka HS C Oven smoking during use and how to stop it?
If your Teka Oven is smoking during use, this is normal during the first use. Ensure you clean the oven regularly to prevent smoking. Also, reduce the amount of fat or oil you're using in your cooking. Finally, make sure you're not cooking at temperatures higher than those recommended in the cooking chart.
What to do if the door of my Teka HS C won't open, but the symbol lights up?
If the door of your Teka Oven will not open while the oven is on and the symbol lights up, the door lock is activated. Turn the control dial to the correct position to unlock it. You may need to deactivate the door lock following the instructions in the User’s guide. Re-select the desired cooking function to continue cooking.
What to do if the door of my Teka HS C Oven won't open when it's off and the symbol lights up?
If the door of your Teka Oven will not open while the oven is off, but the symbol lights up, deactivate the door lock following the instructions in the User’s guide supplied with the manual.
Why has the enamel color changed in my Teka Oven?
If the enamel color in your Teka Oven has changed or stains have appeared, it may be due to the chemical composition of some foodstuffs causing changes in the enamel. This is normal and does not damage the properties of the enamel.
Why are my Teka HS C accessories and shelf supports damaged?
If your accessories and shelf supports are damaged, it is because you did not remove the accessories and supports during the pyrolytic cleaning cycle. You must replace them and remember to remove them during subsequent cleaning cycles.
How to fix the inside light of my Teka HS C if it doesn't turn on?
If the inside light of your Teka Oven does not turn on, first, try changing the bulb. If that doesn't work, check that the bulb has been properly installed as set out in the Installation Instructions.
To Next Page
General
