13
SWITCHING THE APPLIANCE ON
1 Touch the on sensor (1) for at least
one second. The Touch Control will acti-
vate, you will hear a beep and the indi-
cators will turn on. If any of the cooking
areas is hot, the corresponding indicator
will alternate between showing a H and
a 0.
The following action must be carried out
within 10 seconds or the touch control will
automatically switch off.
When the touch control is activated, it can
be disconnected at any time by touching
the sensor (1), even if it has been
blocked (blocking function activated). The
sensor (1) always takes priority for dis-
connecting the touch control.
SWITCHING THE HOTPLATES ON
The hotplates will be found deactivated,
with their respective power indicators (3)
at 0, until a power level is selected. If all
the hotplates are set at 0, you have 10
seconds to activate any of them, otherwise
the touch control will automatically turn off.
Use the sensors and (4/5) to select
a power level. If you touch the sensor
(5), the plate will switch to level 1 and,
for each additional stroke, it will go up one
level until reaching the maximum value of
P. Using the sensor (4), you can redu-
ce the power level.
For a fast powering up at maximum power:
with the plate at 0, touch the sensor (4)
once. The plate will directly activate at
level 9.
By continuing to press down on any of
these two sensors (4) or (5), they
will repeat the action every half a second,
without needing to press consecutively.
SWITCHING THE HOTPLATES OFF
With the sensor (4), lower the power to
level 0.
The hotplate will automatically power off.
For a fast power up: no matter what the
power level, by simultaneously pressing
the sensors and (5/4), the plate will
immediately power off.
By powering off a hotplate, an H will be
shown on the power indicator, if the glass
surface is at a high temperature, indicating
that there a risk of burning. When the tem-
perature has fallen, the indicator will power
off if the top is disconnected or, if it is tur-
ned on, it will indicate a 0.
POWERING OFF THE DEVICE
At any time, you can disconnect the top by
pressing the sensor (1). When doing
this, an acoustic signal is heard and the
power indicators (3) will turn off, except if
there is a residual H heat indicator active
due to the plate temperature.
Locking the sensors
Using the locking sensor (8), you can
block all the sensors on the touch control
panel. This will make it possible to avoid
undesired accidental operations occurring
or children being able to manipulate the
control.
Bear in mind that with the touch control
powered up, the on/off sensor (1)
makes it possible to turn it off even if the
locking is activated (pilot 10 on). On the
other hand, if the touch control is turned
on, the locking function does not allow for
activating the on/off sensor (1). You
should first deactivate blocking.
To Next Page
Loading...
