Teka TMW 22.1 BIT - Oven Maintenance and Care; Oven Cleaning Procedures; Light Bulb Replacement Guide

51
Oven Maintenance
Cleaning
MAKE SURE THAT THE OVEN IS UNPLUGGED BEFORE CLEANING THE OVEN.
DON'T USE ABRASIVE CLEANING PRODUCTS.
OUTSIDE
1. Clean the outside surface with a neutral detergent, warm water and dry it with a damp cloth.
2. Avoid water from entering the oven ventilation holes.
INSIDE
1. Clean the oven walls with a damp cloth after each use.
2. Avoid water from entering the ventilation holes in the oven's interior.
3. If some time has passed by since the last cleaning and the oven's interior is dirty, place a glass of water
on the tray and switch on the oven for 4 minutes on the highest setting. Moisture will form on the oven
walls that will be easily cleaned.
4. The tray can be washed with regular dish washing detergent or in the dishwasher.
DOOR, DOOR SEAL, AND OVEN FRONT
1. These parts should a
These parts should aThese parts should a
These parts should always be clean, especially the contact surface between the door and the oven
lways be clean, especially the contact surface between the door and the oven lways be clean, especially the contact surface between the door and the oven
lways be clean, especially the contact surface between the door and the oven
front, to prevent microwave leakage.
front, to prevent microwave leakage.front, to prevent microwave leakage.
front, to prevent microwave leakage.
2. Use neutral detergent, warm water and dry the surface with a soft cloth.
Light Replacement
In some models the light may be replaced by the user. These ovens have a lid on the left-hand side.
To replace the light, do as follows:
1. Unplug the oven;
2. Remove the lid from the light compartment;
3. Replace the light bulb for a new one (25 W);
4. Replace the lid.
WARNING
WARNINGWARNING
WARNING: in the models without th
: in the models without th: in the models without th
: in the models without the lid to replace the light bulb, this should be done by the Technical
e lid to replace the light bulb, this should be done by the Technical e lid to replace the light bulb, this should be done by the Technical
e lid to replace the light bulb, this should be done by the Technical
Assistance Service because special tools are required.
Assistance Service because special tools are required.Assistance Service because special tools are required.
Assistance Service because special tools are required.