Version 2024 5
7 | Basic health and safety instructions for power tools
Note:
Failure to read and observe these operating instructions may result in serious injury. As with all machinery,
operating a pillar drill can lead to dangerous situations. Careful use and handling can significantly reduce the
risk of injury. Neglecting basic precautions can lead to user injuries. The machine is designed exclusively for
the recommended use. Therefore, do not carry out any work on the machine that is not intended by the
manufacturer and do not make any changes whatsoever. The operating manual is part of the machine. It must
therefore be kept in the direct vicinity of the machine and be accessible at all times.
If you have any questions regarding the use of the machine you cannot find an answer to in these operating
instructions, please contact your dealer.
Workplace safety
a. Keep your workplace clean and well lit. Messy or unlit workplaces can lead to accidents. Ensure there is
sufficient space for operating and guiding the workpieces.
b. For safe operation, it is recommended that the machine is secured to a stable surface. Take measures to
prevent the machine from tipping.
c. Do not use power tools in potentially explosive environments where flammable liquids, gases or dusts
are present. Power tools may produce sparks which could ignite dust or vapours.
d. Keep children and other people away while using the power tool. Distraction can cause you to lose control
of the power tool.
Electrical safety
a. Work on electrical fittings may only be carried out by qualified personnel and in strict observance of the
safety instructions. Disconnect machine from power supply and secure against restarting before carrying out
work at electrical devices.
b. The plug of the power tool must fit into the socket. The plug must not be changed in any way. Do not
use adapter plugs together with earthed power tools. Unmodified plugs and matching sockets reduce the
risk of an electric shock.
c. Avoid physical contact with earthed surfaces such as pipes, heaters, stoves and refrigerators. There is
an increased risk of an electric shock if your body is earthed.
d. Keep your power tool away from rain or moisture. Water entering a power tool increases the risk of an
electric shock.
e. Do not misuse the power cord to carry the power tool, hang it up or pull the plug out of the socket. Keep
the power cord away from heat, oil, sharp edges or moving parts. Damaged or entangled power cords
increase the risk of an electric shock.
f. If operating the power tool in a damp environment cannot be avoided, use a residual-current circuit
breaker. Using a residual-current circuit breaker reduces the risk of an electric shock.
Personal safety
a. Be attentive, pay attention to what you are doing and take the utmost care when operating a power tool.
Do not use a power tool when you are tired or under the influence of drugs, alcohol or medication. One
moment of carelessness when using a power tool can cause serious injury.
b. Only operate the machine if it is in perfect technical condition. Any defects found on the machine or the
safety equipment must be rectified immediately.
c. Wear personal protective equipment and always wear safety goggles. Wearing personal protective
equipment such as a dust mask, non-slip safety shoes, hard hat or ear protection, depending on the type and
use of the power tool, reduces the risk of personal injury.
d. Avoid unintentional starting. Ensure the power tool is switched off before connecting it to the power
supply and/or battery pack, picking it up or carrying it. Carrying power tools with your finger on the switch
or connecting activated power tools to the power supply can cause accidents.
e. Remove any adjusting tool or spanner before turning the power tool on. A tool or spanner that gets caught
in a rotating part of the power tool could cause injuries.
f. Make sure you adopt an ergonomic posture. Ensure secure footing and maintain balance at all times.
This enables better control of the power tool in unexpected situations.
To Next Page
Loading...
