10. Wooden spigot shifts
during turning
Check that the spigot area is made correctly for
jaws to grip. Check that the spigot is not
oversize. See spigot operation instructions
Page 11. Use careful chisel techniques that do
not exert too much pressure Irregular rough
wood blanks need to be checked to see
whether there is enough jaw contact.
11. Wood blank does not seat
properly in internal dovetail
mounting
Check the angle of the dovetail recess made is
the same angle as the jaws. Make sure the
bottom of the recess is flat and square to face.
See dovetail operation Page 10. Check that the
bowl is not incorrectly riding on the flat
shoulder of jaws behind the dovetail.
Extra Support is available on our Website!
Go to www.teknatool.com
or email service@teknatool.com
To Next Page
Loading...