Teknatool SUPERNOVA 2 - Chuck Operation; Using the Allen Key; Contracting and Expanding Jaws

9
CHUCK OPERATION
Adjustment: A handled chuck pinion key is provided for adjustment of chuck action. Please refer
to the exploded drawing on page 6 for location of the two key positions.
TO OPERATE JAWS:
Insert the Allen key into one of the two 22mm guide holes in the SuperNova
2
body. Ensure the
Allen key is sitting firmly into the slot - if not engaged properly tightening power will be reduced
and could result in damage to gear teeth.
TO CONTRACT JAWS:
Turn the handle in an anti clockwise direction to contract the jaws. The direction to
tighten the jaws is shown on the directional arrow. When the action takes up against the
piece held give an extra nip up so jaws securely engage with wood.
TO EXPAND JAWS:
Turn the handle in a clockwise direction to expand jaws.
When the action takes up against the piece held give an extra nip up so jaws securely engage
with wood.