Installing your Built-in Oven
Bringing it all together
Provision for Ventilation
The appliance housing used must provide adequate ventilation.
For built-in installation, a minimum ventilation space of
85 – 90mm 40mm must exist between the rear of the appliance and the back of the housing
or an adjacent wall.
If a tall housing is to be installed flush with the ceiling, a 20cm² ventilation cut-out must be
provided at the top of the housing.
Electrical Connection
This appliance must be installed by a qualified electrician to comply with the relevant Institution of
Engineering and Technology (I.E.T. regulations and also the local electricity supply company
requirements.
This appliance must not be connected to an ordinary domestic power point.
This product comes fitted with a BS plug and cord.
Ensure the cable route avoids the risk of trapping or touching hot surfaces.
The oven is supplied with a BS plug and cord. In the case of replacement of cable or repair, please call our experts on
01759 487823.
Installing Shelves
To Next Page
Loading...