Tektronix 3 - Page 14

Camera System Maintenance—No. 3 Electric Shutter
Reassembly of Electric Shutter
Perform parts a through f if solenoid repairs were made;
skip parts a through f and start with part g if only microswitch
repairs were made.
Reassembly for Solenoid Repairs
a. Install the solenoid onto the front side of the master
plate (engage main level pin in solenoid armature hole)
and fasten with three screws from the rear side of the
master plate. If the solenoid leads are not soldered
to cable, do it now. Refer to the electrical diagram for
wire color.
Solenoid _
armature ~
hole
Three
solenoid -
screws
b. Install the ring plate on the rear of the master plate
with five screws. Check main lever movement for any
binding.
c. Hold the master plate with rear up and install shutter
blades on pins as shown.
d. Still holding the master plate with rear up, install the
shutter case over master plate. When the master plate
is fully installed (position as far in as possible) turn the
assembly over and move springs into proper position.