Need help?Do you have a question about the Tektronix MDO4104-3 and is the answer not in the manual?
General| Bandwidth | 1 GHz |
|---|---|
| Channels | 4 |
| Memory Depth | 20 Mpoints |
| Record Length | 20 Mpoints |
| Vertical Resolution | 8 bits |
| Display Size | 10.4 inches |
| Spectrum Analyzer Frequency Range | 9 kHz to 3 GHz |
| Sample Rate | 5 GS/s |
| Display | 10.4 inch LCD, touch screen |
| Maximum Input Voltage | 400 V (DC + AC peak) |
| Digital Voltmeter | Standard |
| Trigger Modes | Edge, Pulse, Video, Serial |
| Serial Triggering and Analysis | I2C, SPI, RS-232/422/485/UART, CAN, LIN, FlexRay, Ethernet |
Essential safety precautions to prevent harm and damage during operation.
Guides users on configuring analog channels for signal acquisition.
Details various trigger types like Edge, Sequence, Pulse Width, and Bus triggers.
Procedures for setting up triggers for various serial and parallel data buses.
How to trigger acquisitions based on RF signal characteristics like power level.
Procedures for performing automated measurements like frequency and rise time.
Breaking down signals into frequency components for spectral analysis.
Setting up tests to monitor signals against defined masks or limits.
Detailed electrical specifications for analog channels and vertical system.
To Next Page
