Tektronix 3 - Page 15

®
f. Install the Press Focus lever.
h. Fasten cable clamp into position with one screw. Install
a piece of electrical tape to protect wires.
Camera System Maintenance—No. 3 Electric Shutter
. Install the three screws to fasten the master plate to
the shutter case.
Reassembly for Solenoid and Microswitch
Repairs
g. Install microswitches onto the master plate and fasten
with two screws. If microswitches are not soldered to
the cable, do it now. Refer to electric diagram for wire
color.
6-6