Tektronix 7704A Manual

INVENTORY CONTROL TAG
A new inventory control tag is now in use on all modules sent from the Board
Exchange Center . The tag serves two purposes , inventory control and quality
control .
The quality control information is gathered from the " Field Service
Use
"
area of the
tag .
Under normal circumstances , the tag would be used in this fashion : The service
technician per forms an exchange while on site . The tag is removed from the
good module and attached to the defective module . The " Board Exchange " box
is marked
and a
problem
description
is
given .
The
module is
then sent
back
to
Board
Exchange
.
In the event that the module is defective when received by the service techni
cian or is defective when it is taken out of the board kit , the " Defective
from Kit " . box should be checked and a problem description given . The tag is
left attached to the defective module and returned to Board Exchange .
Failure data will be collected from these tags before they are filed . This
data will be
used
in
our
ongoing
efforts to
increase
the
quality
of
modules
received by the field . As in all other information systems , the data out can
be no better than the data in . Please fill out the tag completely .
Written
by-
Barney
Brooks
Module Repair Center
53-017 ,
Ext .
8907 Me
Inserted
by-
Editor
285-0938-00 DEFECTIVE DATE CODES " PURGE "
A previous Wizard article stated that all Capco brand capacitors with
Date Codes 7935 through 7951 were defective . Their defect was that
they were not oil impregnated . There is an indication now that Capco
brand capacitors with Date Codes 7952 through 8007 may also have the
same problem . If Capco capacitors with Date Codes 7952 through 8007
do not appear to be oil impregnated or you are not sure , then I suggest
that
they be
pruged ,
reorder as
necessary
.
--Rich
Andrusco
92-236
,
Ext .
1582
-6
June 27 , 1980
Issue 10-13

Tektronix 7704A Specifications

General

Brand	Tektronix
Model	7704A
Category	Test Equipment
Language	English