Need help?Do you have a question about the Tektronix 7B10 and is the answer not in the manual?
General| Maximum Input Voltage | 400 V (DC + peak AC) |
|---|---|
| Type | Oscilloscope Plug-in |
| Vertical Sensitivity | 5 mV/div to 5 V/div |
| Time Base Range | 0.5 ns/div to 0.5 s/div (with magnifier) |
| Deflection Factor | 5 mV/div to 5 V/div |
| Accuracy | ±3% |
| Delay Range | Up to 10 s |
| Triggering | Internal, External, Line |
| Attenuation | 1X, 10X |
Explains WARNING and CAUTION statements for safe operation.
Covers grounding, cover removal, atmosphere, and damage prevention.
Manual overview, instrument packaging, and installation procedures.
Lists the electrical characteristics and performance requirements of the sweep generator.
Details environmental specifications for the instrument.
Describes the physical properties, including weight and dimensions.
Overview of controls, checkout procedures, and initial setup.
Guides on performing normal and magnified sweep operations.
Information on selecting input impedance for external trigger signals.
Explains switch logic, modes (Auto, HF Sync, Normal, Single Sweep).
Details coupling methods and trigger signal source selection.
Explains control of trigger point based on signal slope and voltage level.
Explains sweep expansion and the function of the hold off control.
Procedure for measuring waveform period and calculating frequency.
Procedures for measuring waveform rise time, fall time, and pulse width.
Information on using the unit with a delaying time-base unit.
To Next Page