To Next Page

To Previous Page

Commands Listed in Alphabetical Order

NOTE. This comm

and will return

PASSED

for probes that do not support degauss

operations.

Group

Vertical

Syntax

CH<x>:PRObe:DEGAUss:STATE?

Returns

NEEDED indicates the probe should be degaussed before taking measurements.

RECOMMENDED indicates the measurement accuracy might be improved by

degaussing the probe.

PASSED indicates the probe is degaussed.

FAILED indicates the degauss operation failed.

RUNNING indicates the probe degauss operation is currently in progress.

CH<x>:PRObe:FORCEDRange

Sets or returns the range of a TekVPI probe attached to the channel speciﬁed by

<x>, where x is the channel number.

NOTE. This command will return

PASSED

for probes that do not support degauss

operations.

Group

Vertical

Syntax

CH<x>:PRObe:FORCEDRange <NR3>

CH<x>:PRObe:FORCEDRange?

Arguments

<NR3> speciﬁe s the range, which is probe speciﬁc.

Returns

This command returns 0.0 for probes that do no support forced range.

H<x>:PRObe:GAIN

Sets or returns the gain factor for the probe attached to the channel speciﬁed by

<x>, where x is the channel number. The "gain" of a probe is the output divided

by the input transfer ratio. For example, a common 10x probe has a gain of 0.1.

MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-105

Tektronix DPO2000 Series Programmer's Manual

Other manuals for Tektronix DPO2000 Series