Tektronix DPO2000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Arguments
CH1–CH4 specifi
es an input channel as the edge source.
MATH specifies the math waveform as the search source.
REF specifies the reference waveform as the search source.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLOCk:THReshold
Sets or returns the clock threshold setting for an setup/hold trigger search to
determine
where to place a mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:SETHold:CLOCk:THReshold
{<NR3>|TTL|ECL}
SEARCH:SEARCH<x>:TRIGger: A:SETHold:CLOCk:THReshold?
Arguments
TTL specifies a preset TT L high level of 1.4 V.
ECL specifies a preset ECL high level of –1.3 V.
<NR3> is the clock level, in volts.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DATa:SOUrce
Sets or returns the data source setting for an setup/hold trigger search to determine
where t
o place a mark. <x> is the search number. You cannot specify the same
source for both clock and data.
Group
Search
Syntax
DPO Models:
SEARCH:SEARCH<x>:TRIGger: A:SETHold:DATa:SOUrce
{CH1|CH2|CH3|CH4|MATH|REF |
D0|D1|D2|D3|D4|D5|D6|D7|D 8|D9|D10|D11|D12|D13|D14|D15}
SEARCH:SEARCH<x>:TRIGger: A:SETHold:DATa:SOUrce?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:SETHold:CLOCk:SOUrce
Arguments
DPO Models:
CH1–CH4 specifies an input channel as the search source.
2-278 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix DPO2000 Series Specifications

General

Brand	Tektronix
Model	DPO2000 Series
Category	Test Equipment
Language	English