Tektronix DPO2000 Series Programmer's Manual

Commands Listed in Alphabetical Order
Arguments
TTL specifies a p
reset
TTL high level of 1.4 V.
ECL specifies a preset ECL high level of –1.3 V.
SEARCH:SEARCH<x>:TRIGger:A:UPPerthreshold:MATH
Sets or returns the math waveform upper threshold to determine where to place a
mark. This setting is applied to all math waveform searches that uses an upper
threshold. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:UPPerthreshold:MATH {TT L|ECL}
SEARCH:SEARCH<x>:TRIGger: A:UPPerthreshold:MATH?
Arguments
TTL specifies a preset TT L high level of 1.4 V.
ECL specifies a preset ECL high level of –1.3 V.
SEARCH:SEARCH<x>:TRIGger:A:UPPerthreshold:REF<x>
Sets or returns the reference waveform upper threshold to determine where to
place a mark. This setting is applied to all reference waveform searches that uses
an upper threshold.
SEARCH<x> is the search number and REF<x> is the reference
channel number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:UPPerthreshold:REF<x> { TTL|ECL}
SEARCH:SEARCH<x>:TRIGger: A:UPPerthreshold:REF<x>?
Arguments
TTL specifies a preset TT L high level of 1.4 V.
ECL specifies a preset ECL high level of –1.3 V.
SELect
Sets or returns the selected waveform display (controlled by the front-panel)
on or off.
Group
Vertical
2-284 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix DPO2000 Series Specifications

General

Brand	Tektronix
Model	DPO2000 Series
Category	Test Equipment
Language	English