Tektronix DPO2012B Programmer's Manual

Commands Listed in Alphabetical Order
:SEARCH:SEARC
H1:TRIGGER:A:BUS:B2:LIN:IDEN TIFIER:VALUE
"XXXXXX";
:SEARCH:SEARCH1:TRIGGER:A: BUS:B1:LIN:ERRTYPE SYNC;
:SEARCH:SEARCH1:TRIGGER:A: BUS:B2:LIN:ERRTYPE SYNC;
:SEARCH:SEARCH1:TRIGGER:A: BUS:B1:PARALLEL:VALUE
"XXXXXXXXXXXXXXXX";
:SEARCH:SE
ARCH1:TRIGGER:A:BUS:B2:PARAL LEL:VALUE
"XXXXXXXXXXXXXXXX";
:SEARCH:SEARCH1:TRIGGER:A: BUS:SOURCE B1
SEARCH:S
EARCH<x>:TRIGger:A:BUS:B<x>:CAN:CONDition
Sets or returns the search condition for a CAN trigger search. SEARCH<x> is the
search number and
B<x> is the bus number.
Conditions
This command requires a DPO2AUTO applic ation module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:CAN:CONDition
{SOF|FRAMEtype|IDentifier| DATA|IDANDDATA|EOF|ACKMISS|ERROR}
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:CAN:CONDition?
Arguments
SOF spec ifies a search based on the start of frame.
FRAMEtype specifies a search based on the frame type.
IDentifier specifies a search based on the frame identifier.
DATA specifie s a search based on the frame data.
IDANDDATA specifies a search based on the frame identifier and data.
EOF specifies a search base on the end of frame.
ACKMISS specifies a search based on the missing ACK field.
ERROR specifies a search based on a bit stuffing error.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:DIRection
Sets or returns the CAN search to be valid for Read, Write, or Either condition if
the criteria is IDentifier.
SEARCH<x> is the search number and B<x> is the bus
number. This only applies if the search condition is IDentifier.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-247

Tektronix DPO2012B Specifications

General

Brand	Tektronix
Model	DPO2012B
Category	Test Equipment
Language	English