Tektronix DPO2012B Programmer's Manual

Commands Listed in Alphabetical Order
MATH specifies t
he math waveform as the search s ource.
REF specifies the reference waveform as the search source.
D0–D15 specifies the digital waveform a s the search source.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:DATa:THReshold
Sets or retu
rns the data threshold setting for an setup/hold trigger search to
determine where to place a mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:DATa:THReshold
{<NR3>|TTL|ECL}
SEARCH:SEARCH<x>:TRIGger:A :SETHold:DATa:THReshold?
Arguments
TTL specifies a preset TTL high level of 1.4 V.
ECL specifies a preset ECL high level of –1.3 V.
<NR3> is the clock level, in volts.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:HOLDTime
Sets or returns the hold time setting for an setup/hold trigger search to determine
where to place a mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :SETHold:HOLDTime <NR3>
SEARCH:SEARCH<x>:TRIGger:A :SETHold:HOLDTime?
Arguments
<NR3> specifies the hold time setting in seconds. Positive values for hold time
occur after the clock edge. Negative values occur before the clock edge.
SEARCH:SEARCH<x>:TRIGger:A:SETHold:SETTime
Sets or returns the setup time setting for an setup/hold trigger search to determine
where to place a mark. <x> is the search number.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-279

Tektronix DPO2012B Specifications

General

Brand	Tektronix
Model	DPO2012B
Category	Test Equipment
Language	English