Commands Listed in Alphabetical Order
UNEQual sets th
e oscilloscope to trigger when the data is not equal to the qualifi er
value.
LESSEQual set
s the oscilloscope to trigger when the data is less than or equal
to the qualifier value.
MOREEQual s
ets the oscilloscope to trigger when the data is more than or equal
to the qualifier value.
Examples
TRIGGER:A:BUS:B1:CAN:DATA :QUALIFIER LESSTHAN sets the oscilloscope
to trigger when the data is less than the qualifier value.
TRIGGER:A:BUS:B1:CAN:DATA :QUALIFIER? might return
:TRIGGER:A:BUS:B1:CAN:DAT A:QUALIFIER THAN, indicating that the
oscilloscope is set to trigger when the data is than the qualifier
value.
TRIGger:A:BUS:B<x>:CAN:DATa:SIZe
Sets or returns the length of the data string in bytes for a CAN trigger if the
condition is DATA or IDANDDATA. Applies to bus <x>, where x is the bus
number.
Conditions
This command requires a DPO2AUTO application m odule.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:CAN:DA Ta:SIZe <NR1>
TRIGger:A:BUS:B<x>:CAN:DA Ta:SIZe?
Arguments
<NR1> is the length of the data string in bytes.
TRIGger:A:BUS:B<x>:CAN:DATa:VALue
Sets or returns the binary data string to be used for a CAN trigger if the trigger
condition is ID or IDANDDATA. Applies to b us <x>, where x is the bus number.
Conditions
This command requires a DPO2AUTO application m odule.
Group
Trigger
2-298 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
