Commands Listed in Alphabetical Order
Arguments
ON or <NR1> ≠ 0tu
rns preview mode on.
OFF or <NR1> = 0 turns preview mode off.
HEADer
Sets or returns the Response Header Enable State that causes the oscilloscope to
either include o r omit headers on query responses.
NOTE. This command does not affect IEEE Std 488.2-1987 Common Commands
(those starting with an asterisk); these commands never return headers. This
command does affect the Response Header Enable State of both the USBTMC and
VXI-11 interfaces. Refer to the Introduction for additional information.
Group
Miscellaneous
Syntax
HEADer {OFF|ON|<NR1>}
HEADer?
Related Commands
VERBose
Arguments
OFF sets the Response Header Enable State to false. This causes the oscilloscope
to omit headers on query responses, so that only the argument is returned.
ON sets the Response Header Enable State to true. This causes the oscilloscope
to include headers on applicable query responses. You can then use the query
response as a command.
<NR1> = 0 sets the Response Header Enable State to false; any other value sets
this state to true.
Examples
HEADER O FF specifies that the oscilloscope omits headers on query responses,
so that only the argument is returned.
HEADER? might return :HEADER 1 indicating that the oscilloscope is including
headers on applicable query responses.
HORizontal? (Query Only)
Returns all settings for the horizontal commands.
Group
Horizontal
2-166 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
