Tektronix DPO2024 Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
HORizontal:DI
Gital:SAMPLERate:MAIN?
HORizontal:POSition
Sets or returns the horizontal position. If Horizontal Delay Mode is turned off,
this command is equivalent to adjusting the HORIZONTAL POSITION knob o n
the front panel. When Horizontal Delay Mode is on, this command stores a new
horizontal position that is used when Horizontal Delay Mode is turned off.
Group
Horizontal
Syntax
HORizontal:POSition <NR3>
HORizontal:POSition?
Arguments
<NR3> is the horizontal position expressed as the p ercentage of the waveform
displayed left of the center o f the graticule.
Examples
HORIZONTAL:POSITION 50 sets the horizontal position to 50%.
HORIZONTAL:POSITION? might return :HORIZONTAL:POSITION 100
indicating that the horizontal position is set to 100%.
HORizontal:PREViewstate? (Query Only)
Returns a boolean value to indicate whether the acquisition system is in the
preview state.
Group
Horizontal
Syntax
HORizontal:PREViewstate?
Returns
<NR1> = 1 if the acquisition system is in the preview state.
<NR1> = 0 if the acquisition system is not in the preview state.
HORizontal:RECOrdlength
Sets the horizontal record length of acquired waveforms. The query form of this
command returns the current hori
zontal record length.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-169

Tektronix DPO2024 Specifications

General

Brand	Tektronix
Model	DPO2024
Category	Test Equipment
Language	English