To Next Page

To Previous Page

Commands Listed in Alphabetical Order

SEARCH:SEARC

H<x>:TRIGger:A:BUS:B<x>:CAN{:IDentiﬁer|:ADDRess}:VALue

Sets or returns the binary address string to be used for a CAN trigger search if

the search condition is ID or IDANDDATA.

SEARCH<x> is the search number

and

B<x> is th

e bus number.

Conditions

This command requires a DPO2AUTO applic ation module.

Group

Syntax

SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:CAN{:IDentifier|:

ADDRess}:VALue <bin>

SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:CAN{:IDentifier|:

ADDRess}:VALue?

Arguments

<bin> is the address in binary format.

SEARCH:SEARCH<x>:TRI

Gger:A:BUS:B<x>:I2C:ADDRess:MODe

Sets or returns the I2C address mode to 7 or 10-bit. SEARCH<x> is the search

number and

B<x> is the bus number.

Conditions

This command requires a DPO2EMBD application module.

Group

Syntax

SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:I2C:ADDRess:MODe

{ADDR7|ADDR10}

SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:I2C:ADDRess:MODe?

Arguments

ADDR7 speciﬁes 7-bit addresses.

ADDR10 speciﬁes 10-bit addresses.

SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:I2C:ADDRess:TYPe

Sets or returns the I2C address type. SEA RCH<x> is the search number and B<x>

is the bus number.

Conditions

This command requires a DPO2EMBD application module.

MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-251

Tektronix DPO2024 Programmer's Manual

Other manuals for Tektronix DPO2024