Tektronix DPO2024 Programmer's Manual

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:RS232C:CONDition
Sets or returns the condition for a RS232 trigger search. SEARCH< x> is the search
number and
B<x> is the bus number.
Conditions
This command requires a DPO2COMP application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:RS232C:CONDition
{RXSTArt|RXDATA|RXENDPacke t|RXPARity|TXSTArt|
TXDATA|TXENDPacket|TXPARit y}
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:RS232C:CONDition?
Arguments
RXSTArt specifies a search based on the RX Start Bit.
RXDATA specifi es a search based on RX Data.
RXENDPacket specifies a search based on the RX End of Packet condition.
RXPARIty specifiesasearchbasedontheRXparity.
TXSTArt specifies a search base on the TX Start Bit.
TXDATA specifi es a search based on TX Data.
TXENDPacket specifies a search based on the TX End of Packet condition.
TXPARIty specifiesasearchbasedontheTXparity.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:RS232C:RX:DATa:SIZe
Sets or returns the length of the data string for a RS232 trigger search if the trigger
condition is RX.
SEARCH<x> is the search number and B<x> is the bus number.
Conditions
This command requires a DPO2COMP application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:RS232C:RX:DATa:SIZe
SEARCH:SEARCH<x>:TRIGger:A :BUS:B<x>:RS232C:RX:DATa:SIZe?
Arguments
<NR1> is the length o f the data string in Bytes.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-259

Tektronix DPO2024 Specifications

General

Brand	Tektronix
Model	DPO2024
Category	Test Equipment
Language	English