Tektronix DPO2024 Programmer's Manual

Commands Listed in Alphabetical Order
Syntax
BUS:B<x>:PARa
llel:WIDth <NR1>
BUS:B<x>:PARallel:WIDth?
Arguments
<NR1> is the number of bits.
BUS:B<x>:POSition
Sets or returns the position of the bus <x> waveform on the display, where x is
the bus number 1 through 4.
Conditions
This command requires a DPO2AUTO, DPO2EMBD, or D P O2COMP application
module.
Group
Bus
Syntax
BUS:B<x>:POSition <NR3>
BUS:B<x>:POSition?
Arguments
<NR3> specifies the position.
BUS:B<x>:RS232C:BITRate
Sets or returns the RS232 bit rate for bus <x>, where x is the bus number.
Conditions
This command requires a DPO2COMP application module.
Group
Bus
Syntax
BUS:B<x>:RS232C:BITRate <NR1>
BUS:B<x>:RS232C:BITRate?
Arguments
<NR1> is the bit rate in bits-per-second: 50 to 10000000. You can enter any
positive integer, and the instrument will coerce the value to the closest supported
bit rate.
2-82 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series O scilloscopes Programmer Manual

Tektronix DPO2024 Specifications

General

Brand	Tektronix
Model	DPO2024
Category	Test Equipment
Language	English