EasyManuals Logo

Tektronix DPO4034 Instruction Manual

Tektronix DPO4034
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #130 background imageLoading...
Page #130 background image
Locating Signals
Description. There are two less-frequent anomalies in this pulse train that can show up with DPO on DPO3000, MSO3000,
DPO4000, and MSO4000 instruments.
A half-height runt signal occurs app roximately every 838.8 ms. Use a Runt trigger to isolate the signal.
A 50 ns (narrow) pulse appears in approximately 838.8 ms. Use a Pulse Width trigger to isolate the signal.
The pulse train is a repeating group of three pu lses. The three pulses are 100 n s, 200 ns, and 100 ns wide, with a 100 ns
low between each pulse. The group repeats at a 1.6 μs rate.
The anomaly is a group of four pulses. The four pulses are 100 ns, 50 ns (narrow), 100 ns (runt), and 100 ns wide, with a 100 ns
low between each pulse, except for a 50 n s low before the runt.
40 MHz
Board label. 40_MHZ
Connector g rid location. A4
Description. This is a 40 MHz square wave signal.
AM Modulation
Board label. AM_MOD
Connector g rid location. I5
Description. This is a 1.25 MHz carrier amplitude signal modulated by a 1.25 kHz sine wave signal.
124 Demo 2 Board Instruction Manual

Table of Contents

Other manuals for Tektronix DPO4034

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix DPO4034 and is the answer not in the manual?

Tektronix DPO4034 Specifications

General IconGeneral
BrandTektronix
ModelDPO4034
CategoryTest Equipment
LanguageEnglish

Related product manuals